Re: [sipx-users] ITSP call goes through but no audio
On Thu, Jul 2, 2009 at 5:18 PM, Matt Keys<MKeys@xxxxxxxxxxxxxxxxx> wrote:
>
> The ITSP told me it was disabled. For S&G's he enabled it for one test call
> and then disabled it afterward--it had no effect. This happened before I
> forcing G.729 on the phone though. It'll be Monday before I can test with
> him again. What do you suggest the next test should be?
>
> Thanks,
> Matt
There is a "use public addressing for call setup" switch that you may
want to experiment with. It is on the "advanced" section of the iTSP
configuration page.
Ranga
>
>
> -----Original Message-----
> From: Scott Lawrence [mailto:scott.lawrence@xxxxxxxxxx]
> Sent: Thu 7/2/2009 4:50 PM
> To: Matt Keys
> Cc: sipx-users@xxxxxxxxxxxxxxxxxxx
> Subject: Re: [sipx-users] ITSP call goes through but no audio
>
> There is no rule that says codecs must be the same in both directions.
>
> I doubt this is your problem - it is much more likely a NAT traversal
> issue. Is Covista Communications doing any NAT compensation on their
> end - if so, see if you can turn it _off_ so that only one end is
> compensating for the NAT.
>
>
>
> _______________________________________________
> sipx-users mailing list sipx-users@xxxxxxxxxxxxxxxxxxx
> List Archive: http://list.sipfoundry.org/archive/sipx-users
> Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-users
> sipXecs IP PBX -- http://www.sipfoundry.org/
>
--
M. Ranganathan
